HighBuild™ Poured ESD Epoxy
Floor Coating
HighBuild is a static conductive, three layer ESD epoxy coating manufactured for high traffic manufacturing , assembly and static sensitive areas where a glossy finish is preferred.
-
20 mil thick three layer epoxy – Less than $2/sq ft
-
Can be installed over wood, old VCT floors and concrete
-
High Gloss Finish- Never requires waxing or buffing
-
Quick turnaround – Light traffic 12 hours after application
-
Permanent Static control – 5-Year Limited ESD Warranty
-
Electrical Resistance 1.0 x 10e5 to 5.0 x 10e5
-
Limits static charge generation to less than 15 volts
-
Chemical and abrasion resistant
HighBuild Conductive Epoxy meets all of the ESD technical flooring requirements of ANSI/ESD S20.20.
Triple Component Installation
Three separate coats are required when installing this product:
-
Primer Base Coat
-
Conductive Ground Plane
-
ESD Top Coat
These three layers build up to a 20 mil thick conductive ESD epoxy floor that will withstand heavy forklift and heister traffic as well as providing a conductive ESD floor for areas working with open circuit boards and static sensitive equipment.
The Top Coat layer is available in three colors: Medium Blue, Medium Green, and Medium Gray.
 Medium Blue |
 Medium Green |
 Medium Gray |
Maintenance
To maintain the HighBuilds high gloss finish, use the following procedures.
-
Dust mop on a regular basis as needed.
-
Damp mop with a neutral PH detergent as needed or scrub periodically with an automatic scrubber using a neutral PH detergent and NON-ABRASIVE scrub pads such as white, red or tan polished pads.
Applications
Appropriate applications for this type of floor finish include:
- Manufacturing & assembly areas
- Research & Development
- Computer storage and warehousing areas
- Component Testing and Repair
How to order
Call Staticworx Corporate offices at 617-923-2000.
